您好,Dongguan Xiahui Automation Equipment Co., Ltd.网站欢迎您!

专注喷涂设备生产销售及自动化设备方案设计等服务
咨询热线

13649892329

您的位置:Home > Industry knowledge > Content

What are the advantages of automatic fuel injectors compared to manual

2020-07-16

What I have always told us before is about the advantages of automatic fuel injectors compared to manual fuel injection. The same automatic fuel injectors are assumed to be used carelessly, but they also have some shortcomings. For example, there are two shortcomings that are easy to occur during the injection process of automatic fuel injection equipment-the causes and treatment methods of lax concealment and fish eyes.

1. Poor concealment of the shortcomings of fuel injection:

Also known as translucent or bleeding. The color paint cannot completely conceal the color of the original paint surface, or the color of the old paint film or the color of the primer layer penetrates into the top paint layer, changing the color of the top paint. The red and yellow paint layers have more bleeding.

(1) Cause

① Accumulation of colored paint. After the topcoat was diluted, the paint was not sufficiently stirred, and the pigment accumulated on the bottom of the container, which caused the resin content in the sprayed paint to be too high and the color became lighter.

② Faulty spraying technology. For example, each subsequent coating is not sprayed repeatedly, resulting in striped paint surface or hidden defects.

③Too much thinner is used, so the paint coating becomes very thin.

④The old paint layer or the bottom layer coating is rich in pigments that can cause color bleeding. Therefore, the old paint layer should be handled carefully, and an insulating layer can be sprayed to prevent color bleeding.

(2) Correction method

Assuming there is fine bleeding, you can spray satisfactory paint for concealment. Regarding the paint surface with serious bleeding, it should be polished off and sprayed from the beginning.

2. Fisheye of the disadvantages of automatic fuel injection:

Fish eyes are also called shrinkage holes or bead holes. Small round pits appear on the topcoat, sometimes slack and sometimes clustered.

(1) Cause

① Wax containing silicone is a common element that causes fish eyes. Abrasives on sandpaper and many car waxes and polishing agents are rich in silicone. Silicone has strong adhesion on the paint surface and is difficult to eradicate. A very small amount of car wax will cause the appearance of fish eyes, so it should be ensured that all the work that touches the silicone is carried out in an isolated work room away from the fuel injection workshop.

②The surface of the primer is contaminated, such as oil on the primer, so the surface of the spray must be cleaned before spraying, and a neutral detergent can be used.

③Seriously filter the compressed air used by the spray gun to ensure the innocence of the compressed air, because silicones are often found to come from compressed air pipes rather than paint. The compressed air filter is drained and cleaned every day to discharge the moisture and dirt in the filter, and the air compressor should be drained every day.

④It is not recommended to use color paint rich in anti-fisheye remover, because the remover may contaminate other sprayed parts of the surrounding sprayer equipment, and in severe cases, it may reduce the adhesion of the topcoat.

(2) Correction method

Eradicate the affected area and spray oil from the head.


Related News

Product Recommended

  • Small side mould machine
  • Small clamp injection...
  • Clamping mold injecti...
  • Hinge mold automatic ...
  • Large clamp mold auto...
  • Intelligent flat spra...