With the development of industrial technology, pure handwork can no longer satisfy the needs of shopping malls. Spraying has been developed from manual to industrial automation, and the degree of automation is getting higher and higher. Therefore, the use of spraying production lines has become more and more extensive. To many areas of the national economy. In our country, especially after the reform and opening up, spraying equipment has achieved useful development. How to improve the production efficiency of spraying equipment during work.
1. Regular inspection and maintenance of small spraying equipment, screening out the equipment with outdated or aging performance. Regarding the warranty period, the expensive repair cost or the electrostatic spraying equipment that cannot be repaired by the original manufacturer, the repair time and cost will affect the overall Benefit, need to be replaced, some workpieces are more difficult to spray, a set of high-performance electrostatic spraying equipment can be used as a spare. It is necessary to keep pace with the times. When conditions permit, use electrostatic spraying equipment with high spray efficiency and high paint utilization rate to reduce the appearance of defective products, reduce rework, and improve overall work efficiency.
2. A well-equipped powder recovery system can reduce the serious pollution to the workshop caused by the rebounding powder, and it may reduce the waste of the powder. From a long-term point of view, adding a powder recovery system is more beneficial than masking. For the recovery system with poor performance, long-term use has not achieved the expected effect of the recovery system and can be replaced. If the company's production scale expands and new stations are added to improve spray production capabilities, the recovery system should also keep up.
When using small spraying equipment, you need to be careful not to aim the spray gun at any part of the body, and not to make any part of the body touch the liquid stream. Do not touch your body with the fluid flow caused by leaking pipelines. Gloves cannot effectively prevent eruption injuries. When spraying, the nozzle maintenance equipment must be in place. Nozzle maintenance equipment provides some maintenance for eruption damage, but it is basically a warning device. Before flushing or cleaning the system, the nozzle must be removed.
Check the paint tube before each use of the small spraying equipment. The abrasion, twisting and rough use of the paint tube will cause it to leak, and the leaking paint tube may inject the paint into the skin. If there is no trigger, or if the trigger is not opened and the spray gun is not working properly, it is absolutely impossible to use.
If the construction personnel find that the eruption enters the skin, the wound must be surgically treated as soon as possible. Do not delay the treatment of wounds due to toxicity studies. When spray materials are sprayed directly into blood vessels, toxicity is a consideration. However, experts said that if the correct method of operation of this equipment is understood clearly before construction, these problems can be prevented! Spraying equipment is also called coating equipment. Specifically, it is a special tool for covering the maintenance layer or decoration layer on metal and non-metal surfaces.