您好,Dongguan Xiahui Automation Equipment Co., Ltd.网站欢迎您!

专注喷涂设备生产销售及自动化设备方案设计等服务
咨询热线

13649892329

您的位置:Home > news > Content

Brief introduction to the process of glaze spraying small spraying equipment

2020-09-15

Small-scale glaze spraying equipment The glazing site is a high-dust production workshop. The design and selection of all spraying equipment should give priority to dust-proof, glaze-proof, and water-sealed. Glaze powder particles are prone to occur in the production of glaze spraying. Because the glaze slurry is highly viscous, it is easy to agglomerate and is not easy to clean. It is necessary to fully consider the convenient recovery design of the glaze in each spray booth. During the process of synchronous belt planting and transportation, the product should be prevented from being damaged due to abnormal forces such as uneven force on the bottom of the product, vibration, and jumping teeth. The product damage rate of the entire spray glaze production line due to equipment failure is less than <0.5‰ ay,="" and="" the="" failure="" of="" the="" entire="" line="" shutdown="">4H (except due to the operation of Party A) ≤1 times/year, and the maintenance time of the simple shutdown failure ≤0.5 H/times and ≤2 times/week.

The glaze filling machine of the small spraying equipment for spraying glaze is selected offline glazing, and the structure is satisfied with the wild design of the inland row and wall row products in the attached drawings. The bottom scrubbing machine should prevent the scrubbing unevenness of the two sets of sponge wheels in staggered orientation, and the mechanism is easy to disassemble and adjust. Before designing the structural details of the small glaze spraying equipment, it is necessary to fully understand the glazing process and the on-site operation process to ensure that the design of the equipment meets the production process and on-site operation requirements! The glaze spraying production line requires that the production capacity of the spraying robot glazing line is satisfactory for 10 hours or more than 900 pieces, and the average cycle time of each process is 40s. In order to balance the production cycle, 1-2 buffer positions are reserved before and after each work station. The robot glazing line is cleaned daily , Maintenance time ≤30min.

This point is the on-line point of the first phase of the glaze application. The product is transported to the belt line by a manual assist arm at the loading point. The power arm transfers the product from the transportation line to the manual feeding synchronous belt line, and the product line is updated and displayed on the large operating screen in real time. When the line is abnormal, the line can be added and removed after manual recognition. The glaze filling machine adopts the method of online glaze filling. The spraying equipment does not rotate as a whole, seals the seat ring surface and the water tank drain and the abdominal flush water inlet of the smart toilet, and uses the blast method to discharge the glaze.


Related News

Product Recommended

  • Small side mould machine
  • Small clamp injection...
  • Clamping mold injecti...
  • Hinge mold automatic ...
  • Large clamp mold auto...
  • Intelligent flat spra...